Lokfix S25

Lokfix mix and place anchoring grouts are used for: high-strength corrosion-resistant anchoring of bolts and bars into concrete, rock, masonry or brickwork where high speed of installation and early application of load is required

Fosroc Conbextra GP

Conbextra GP is used for free flow, non-shrink, cementitious grouting of gap thicknesses 10 to 75 mm. Supplied as a ready to use dry powder, the addition of a controlled amount of clean water produces a free-flowing grout for gap thicknesses up to 75mm.

Conbextra-EP-521

For grouting under baseplates, crane rails, turbines where heavy dynamic loads are encountered and areas where chemical spillage may occur.

Nitomortar-PE-1018

For fast and emergency reinstatement of concrete, bedding, jointing and reprofiling of concrete, masonry and brickwork. Nitomortar PE is ideally suited for the repair and reprofiling of precast concrete units, damaged arrises and treads.

WEBAC-4170T

WEBAC 4170T is a CE-certified low viscosity epoxy injection resin suitable for various crack conditions, also at low temperatures.

Conbextra-GP

Conbextra GP general purpose grouting is used where it is essential to eliminate shrinkage when completely filling the void between a base plate and a substrate.

Conbextra-HF-0419

Conbextra HF is used for free flow, non-shrink, cementitious grouting of gap thicknesses 10 to 100 mm.

Nitokit-LV-and-TH-1020

Nitokit LV and Nitokit TH are designed for injecting cracks in concrete and masonry where there is a need to consolidate a structure or exclude water and air from contact with reinforcement.

Super FG

Super FG is a pre-mixed magnesium phosphate cement blended with specially selected aggregates. The resulting mix produces a mortar which gives rapid setting and high early strength properties suitable for works carried out in raising or lowering carriageway frames and covers.